Acard PCI-to-IDE ATA-133 Manuale Utente Scaricare il pdf (Pagina 15)

Page 15

Rebuilding a Failed RAID 0+1 Set

The steps below will guide you in rebuilding a failed Mirror-Stripe set.

1. Replace the failed drive with one of identical size or of large

capacity.

Note: It is recommended to replace the bad drive with an identical

drive, or with a drive of the same make. In all cases, the replacement

drive must be of equal or larger capacity then the bad drive.

2. Start the computer and during boot press F3, when prompted, to

enter the RAID BIOS.

3. Press F3 to assign a Spare drive.

4. Press the number corresponding to the new drive.

5. When asked Are You Sure?, Press Y to accept.

6. Press ESC to exit the RAID BIOS and reboot the computer.

7. Continue with FDISK and FORMAT steps as if you were

installing a conventional hard drive.

Deleting RAID Arrays

1. As the BIOS boots press F3 when prompted to enter the RAID

BIOS.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Nessun commento

Acard PCI-to-IDE ATA-133 Manuale Utente Pagina 15