Acard PCI-to-IDE ATA-133 Manuale Utente Scaricare il pdf (Pagina 6)

Page 6

Note: Only the 40-pin/80-wire UltraATA cable can achieve hard disk

UDMA 133 performance. When attaching only two hard drives it is

recommended that they be connected on separate IDE channels.

In order to achieve high-speed data transfer, a 40-pin/80-wire Ultra

ATA ribbon cable is recommended. Also, do not mix Ultra ATA/133

hard disk with slow IDE or ATAPI devices on the same channel.

1. If you plan to install two hard disk drives on the IDE1 channel,

make sure to configure one drive as Master and the drive as Slave.

Follow the hard drive manufacturer’s instructions for the correct

jumper setting. The same rule must be followed for connecting

hard disk drives to the IDE2 channel.

2. Attach on end of the Ultra ATA cable to the IDE1 connector on

the board. Make sure pin 1 on the cable(indicated by the stripe)

matches pin 1 on the IDE1 connector.

3. Install the hard disk drive to your computer. Attach the end

connector of the Ultra ATA cable to the end connector on the hard

disk drive. Make certain that pin 1 on the cable(indicated by the

stripe) matches pin 1 on the hard disk drive’s connector to IDE2.

Note: The ribbon cable has two connectors. If you have one hard disk

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Nessun commento

Acard PCI-to-IDE ATA-133 Manuale Utente Pagina 6